![icom ic-rs-ba1 download icom ic-rs-ba1 download](https://www.ameradio.com/img/products/Icom-RS-BA1-s.jpg)
![icom ic-rs-ba1 download icom ic-rs-ba1 download](https://i2.wp.com/m0iax.com/wp-content/uploads/2021/03/18.jpg)
DATA OFF MOD will automatically change in the radio to LAN when we connect.To use the Scope in RS-BA1 we need Unlink from setup properly in the radio.It will switch ON automatically if it is OFF. When we use RS-BA1 to connect to the radio we need CI-V Transceive ON in the radio.For now it’s working and I get “good” audio reports on SSB. Once I am more familiar with RS-BA1 I’ll do another video and show how I fined tuned my software to transmit SSB, and CW. I have a tip in the video for setting the F1 key on the keyboard for TX/RX. With the “REMOTE” enabled you can control the radio. See pictures and video below.Ĭlick the Power On or Connect button in the RS-BA1 Remote Control. Have a look at the Remote Setting and the MOD Select. When setting up the Connect Set in RS-BA1, you can use LAN (thanks Jeff, W6FCC ) for the Connection instead of USB. This is in the video below.Īfter you are connected to the radio with the Icom Remote Utility program open the Icom Remote Control program. Just verify that you use the same virtual COM port # in the Remote Control as you have set in the Utility software. The COM port you select is a virtual port, so the # is not important. Open the Utility and click on the “Add” button to setup and connect to the sever. Scroll down on that page to find the RS-BA1 section.
#Icom ic rs ba1 download install
The Remote Utility software and the Remote Control software.Īfter installing those from the CD-ROM, go to the Icom website and install the latest update. Two software applications are installed off the CD-ROM. You’ll need to buy a CD-ROM with RS-BA1 software if you don’t already have it. Icom 7610 RS-BA1 Utility and Remote Software See Icom 7610 Screen Captures and “Things to watch out for”. When powering off the radio, put it in Standby (For remote control). That’s not a big deal and doesn’t need to be changed if you don’t want to. I’ll bet a lot of Hams are using MIC, ACC and I use MIC,USB. Try to determine if it is necessary to change yours. There may be one or two things different from your radio configuration. In the video below you’ll see how I have my radio setup. More information can be found here: Icom 7610 Clock, Timers and Network. First, connect the Icom 7610 to your network with the ethernet port on the rear of the radio.